Please watch the instructional video below to learn how to install the Electronic License Plate:
If the ePlate is not operating as it should, check the following:
Make sure the batteries are fresh and inserted properly in the remote control.
ake sure power is going to the eplate by pressing the brake pedal so the message will scroll.
Make sure all wiring connections are secure and hooked up to the right polarities (negative to negative, positive to positive).
When entering a message make sure you are pointing the remote at the base of the ePlate from about 4 to 10 feet away.
To have the brake light operate properly make sure you have attached the grey wire to the red wire and then to the live(positive wire) of your vehicle's brake light.
If message is scrolling upside down aim the remote control at LED panel and press the "inv."button. www.tanix.org
